Skip to main content

Volvo EC330B Pump Flow Control

This illustration show Volvo EC330B pump flow control.

Volvo EC360B Pump Flow Control

At job site, customer uses various kind of optional attachment like hammer, shear etc. Every attachment has their unique operating specification especially in flow. Our machine can satisfy this request by using flow control switch and flow control proportional valve.
1. When operator adjust flow control switch, display automatically shows the flow value at the present engine rpm. 

2022 Volvo PTT Premium Tech Tool PTT 2.8.130/2.7 & 2.6
 

2. When operator uses the option attachment, the pilot pressure switch will be activated. V-ECU receives this signal and then start to controls the flow control valve according to flow control switch position. If the pilot switch is off position, there is no output current from V-ECU. That means flow control function is engaged only during the working of optional attachment.

Volvo IMPACT EPC 06.2021

Labels:

Comments

Post a Comment

Popular posts from this blog

Volvo EC330B Excavator Battery Relay & Safety start Relay

Volvo EC330B Excavator Battery Relay & Safety start Relay Battery relay This is main relay for electric system. Volvo PTT Techtool 2.8.130 The relay turns the battery current ON or OFF, according to low power signals received from the start switch. Use of the relay permits the start switch to control the power of the batteries with a small capacity wire. When you replace this component, pay attention to the +/- signs on the relay. Wrong connection can cause early failure of relay. 2. Safety start relay When trying to restart the engine while the engine is running, or if the start switch is in the START position after the engine is activated, the relay cuts off the current to the starter motor to protect it.
Post a Comment
Read more

Volvo EC330B Excavator Electronic Control System Overview

Volvo ECB330B Excavator Electronic control system overview   Volvo ECB330B Electronic control system is composed of various computers and its communication line. In our system, 2 computer (EECU, VECU) is programmable and 1 computer (MDU) is not. Volvo Tech Tool Communication is important thing to control the machine properly. We use two communication lines that is international protocol. The line is twisted to protect the bus from electrical interference.
Post a Comment
Read more

Volvo EC330B Excavator Engine Start and Stop Circuit Old Overview

Volvo EC330B Excavator Engine Start and Stop Circuit Old Overview  Volvo PTT Procedures: Engine Start and Stop Circuit(Old) Power from battery => electric greasing system,start key,start motor,battery relay Power from battery relay =>safety start relay Vocom 88890300 1) Key ON  BR=> Battery relay,alternator(15,pre-magnetization)  ACC=>VECU,Air conditioner,EMS power relay 2) Key Start  R2=> VECU  C=> safety start relay 3) Engine running  Alternator(L)=>hour meter,safety start relay,VECU(charge lamp off)  * Resistor between alternator and BR termainal for quick charge lamp off  Alternator(B+)=>alternator(BS,voltage sensing for regulation)  Alternator(15)=>battery relay 4) Key Off  VECU(JA61)=>battery relay
Post a Comment
Read more