Skip to main content

How to Install Bucket Cylinder Protecting for Volvo EC210B Excavator

This instruction show you guide on how to install bucket cylinder protecting guard for Volvo EC210B excavator.

Preparations:

Volvo PTT Diagnostic software free download

Volvo PROSIS 2019 EPC+Service Manual Free Download

 

Procedures:

Park the machine in in the service position A

Install clamp (1) and screws (2).(2).


NOTE!
Apply loctite on screws
Tightening torque: 111 ±11 Nm (82 ±8 lbf ft)
Install pll plates (3) and screws (4)

Install links (7), collarllars (6) and screws (5).5).

Install I-bolts and sling guard (8) securely with a hoist.

The parts are heavy. Take appropriate safety cautions when handling them.
Install cover (10), screws (11) and check for interference of guard by operating the bucket cylinder

Volvo Vocom 88890300

Labels:

Comments

Post a Comment

Popular posts from this blog

How to Remove and Install Sink Drain Assembly for Volvo VN770 Truck

This instruction show you guide on how to remove and install sink drain assembly for Volvo VN770 truck. Volvo Tech Tool 2022
Post a Comment
Read more

Volvo EC330B Excavator Battery Relay & Safety start Relay

Volvo EC330B Excavator Battery Relay & Safety start Relay Battery relay This is main relay for electric system. Volvo PTT Techtool 2.8.130 The relay turns the battery current ON or OFF, according to low power signals received from the start switch. Use of the relay permits the start switch to control the power of the batteries with a small capacity wire. When you replace this component, pay attention to the +/- signs on the relay. Wrong connection can cause early failure of relay. 2. Safety start relay When trying to restart the engine while the engine is running, or if the start switch is in the START position after the engine is activated, the relay cuts off the current to the starter motor to protect it.
Post a Comment
Read more